Initialize a microcontroller system, which take care setup procedure like powering up peripherals, set clock rate etc.Ĭonnect necessary pin using pin connect block. While writing an application to blink LED, we have to follow general steps: Writing zero does not have any effect and hence it can’t be used to drive a pin to Logic 1 This register can be used to drive an ‘output’ configured pin to logic 0 i.e. For driving pins LOW IOxCLR is used which is explained as below:

Writing zero does not have any effect and hence it can’t be used to drive a pin to Logic 0 i.e.

This register can be used to drive an ‘output’ configured pin to logic 1 i.e. Setting a bit to ‘0’ in this register will configure the corresponding pin to be used as input while setting it to ‘1’ will configure it as output. This is the GPIO direction control register. It gives the current state of GPIO pin when read. Regardless of the direction set for the particular pins. This register can be used to read or write values directly to the pins. Please maintain attribution to SparkFun Electronics and release anything derivative under the same license.Lpc2148-keil-LED-BLINKING-using-keilv4-proteus. Please use, reuse, and modify these files as you see fit. Anything that was co-writing with Peter Jansen is BSD. Anything SparkFun wrote is beerware if you see me (or any other SparkFun employee) at the local, and you've found our code helpful, please buy us a round! Anything Maxim wrote has its own license.

Various bits of the code have different licenses applied. Hookup Guide (MAX30101) - Basic hookup guide for the SparkFun Photodetector (MAX30101) - Qwiic.Hookup Guide (MAX30105) - Basic hookup guide for the MAX30105 Particle Sensor breakout board.Product Repository (MAX30101) - Main repository (including hardware files) for the SparkFun Photodetector (MAX30101) - Qwiic.Product Repository (MAX30105) - Main repository (including hardware files) for the MAX30105 particle sensor breakout board.Installing an Arduino Library Guide - Basic information on how to install an Arduino library.library.properties - General library properties for the Arduino package manager.keywords.txt - Keywords from this library that will be highlighted in the Arduino IDE./src - Source files for the library (.cpp./examples - Example sketches for the library (.ino).Library written by Nathan Seidle ( SparkFun) and Peter Jansen ( Open Sensing Lab).

This library should work with other MAX3010x sensors including the MAX30102, MAX30101, and MAX30100. This is a breadboard friendly breakout board for the Maxim MAX30105 reflectance, particle, and pulse ox sensor. SparkFun Reflectance, Particle, and Pulse Ox sensor - MAX30105 (SEN-14045)

Lpc2148 library for proteus 8